Action disabled: source

Selection using the mouse

How?
First ensure that the mouse is in the select mode. You then need to drag the mouse and trap the corners of those objects which you want to go into the selection set.

Warning: If you drag and mark out a rectangle in an empty area of the site i.e. one which has no corners of shapes at all; you will end up changing the step-size of the architect instead of changing the selection set

If there are objects that were previously selected, they would now get unselected.

Once selected, some commands will make TAD work on all of them together. For example, you can shift them together, rotate them together and so on… even some editing commands can be worked on them together

Selected objects will now be shown in blue dotted lines. The number of objects selected would be shown at the bottom part of the Information Panes

Deselection
If you repeat the same action of trapping the corners of selected objects; then the command gets reversed: The selected objects now gets unselected

The number of items that are currently selected can be seen in a small box below the information tab which is usually located at the left side

See also: Select Mode | Select with mouse | Select All | Select None | Select Previous | Select Class | Suspend Selections | Hide Current Class | Hide Selection set | View Current Class | View Current Class and Descendents | View ONLY current class | View all

2019/04/13 08:17 · admin

Press F1 inside the application to read context-sensitive help directly in the application itself
Last modified: le 2023/04/22 20:59