Differences

This shows you the differences between two versions of the page.

@@ Line 1: / Line 1: @@
+===Offset beak alignment==
+This is similar to [[beakalign|beak alignment]], so kindly read that first and come back here
+Additionally, this functionality comes up when you have the yellow command line available on the screen with a numeric value (either direct or calculated) inside the command line. If such a value (non zero) is available, then the two objects used for the //beak align// functionality need not have a common coincident vertex.
+Instead, it would intelligently move object "b" in such a way that its first helper is coincident with the first helper of object "a" and then it would further rotate it (just as in the //beak alignment//) so that b's current edge is coincident with a's first edge. And even more ... it would then shift "b" by the exact value you had specified in the command line.
+This action is specifically useful when you need to leave the required left-over gap between two space to represent the wall between them.

TAD Docs